So, why would imperfect sound be one of the perfect genres to study to? Sit back and take a listen as you hear why. Unlike hi-fidelity, or hi-fi, which is the high-quality reproduction of sound, the imperfect elements of lo-fi music are a popular choice when it comes to the positive results when studying is concerned. Low-fidelity music, or lo-fi, is music that is recorded with intentional imperfections, such as misplayed notes, environmental noise, low hum, or phonographic audio imperfections. Haven’t heard of lo-fi music? Grab your earbuds as we tell you all about it. It’s called “lo-fi,” and it’s getting high marks from students across the globe for its positive effects on helping them bring their A-game when it comes to reducing stress, increasing focus and keeping them relaxed while studying. But did you know that certain genres of music could set the tone for even greater concentration, focus and well-being?Īs we kick off a new semester, we’d like to introduce the latest music craze to add to your study playlist. The chain looks like this on our drum channel.If you study to music, then you’re already “in tune” with the amazing effects it may have for helping put your brain in optimum study mode. Then we’ve got SUPERCHARGER adding some compression and grit to our sound. We’ve dialed some settings to keep things sounding muted and smudgy, while still preserving the essence of our sound. We’ll start with using SOLID EQ, which mimics the way that analog solid-state EQ hardware works. So for our example, we’ve added an EQ and a saturation/compression unit to each of our instrument channels. The two of these steps combined will make the tone feel warm and chill. This is a way to add some dust, or grit to our sound. Another great way to get lofi tone is to use distortion and saturation to make things sound dusty. That means cutting off everything below 200 Hz, and everything above 5K Hz. That’s easily achieved with a few quick steps.įirst, we’re going to use EQ to mimic the limited bandwidth of vintage radios by cutting off the lowest and highest frequencies. In lofi, we’re going for smudged, dusty and warm sounds that mimic faulty vintage equipment. As we mentioned earlier, lofi is short for “low fidelity”-a way of describing how clean or “true” something sounds. Not enough change makes it boring, but too much change loses the chill.Ī common feature to all Lofi beats is right in the name. We don’t want things to go crazy, we’re just adding a barely-perceptible difference occasionally. The trick to this is that a little bit goes a long way. You can also make small, occasional changes to the other instruments using the same principle. They’ll also drop out occasionally, or have a quick fill. One or two notes might be a little late, or a little early. This involves sliding the drum notes just a little bit off the grid. Well there’s a big difference between simple and boring! We don’t want boring-and a great way to do that is to add little variations and imperfections to the beat. Remember in the first tip we said to keep the beat simple. Some ways we can add imperfections start with the drums. This helps balance out the chill feeling with just enough flavor to feel unique and cool to listen to. When we’re making Lofi beats, we want to find sneaky ways to keep the music interesting, and just a little bit different.
0 Comments
Leave a Reply. |